US Robotics COURIER Bedienungsanleitung PDF herunterladen (Seite 53)

100

101

U.S. Robotics I-modem Command Reference

Working with Memory • Page 4-19

&W To substitute a template other than &F1, write the desired template to NVRAM

using the &W command.

AT&F2&W <Enter>

To modify the &Fn conÞguration in NVRAM, type your changes afterward and then save

them to NVRAM, as in the following example (the original factory template remains

intact):

ATS10=40&A2&W <Enter>

Resetting I-modems

Z or Z!Resets and loads the NVRAM settings when DIP switch 1 is ON (factory setting).

If DIP switch 1 is OFF, the I-modem resets and loads the &F0 conÞguration tem-

plate (no ßow control). Use ATZ or ATZ! to make changes to the DIP switch set-

tings take effect immediately.Table 4-5. &F0 No Flow Control Template

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 307 308

Kommentare zu diesen Handbüchern

Keine Kommentare

US Robotics COURIER Bedienungsanleitung Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung US Robotics COURIER