US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Bedienungsanleitung PDF herunterladen (Seite 40)

56K Softmodem

Command Reference

- 34

Table 3-49: Valid <v8o> Values

Table 3-50: Valid <v8a> Values

Table 3-51: Valid <v8cf> Values

Table 3-52: Valid <v8b> Values

Table 3-53: +A8E Extended Syntax Commands

Note:* ITU-T recommendation V.251 (02/98) standardized this command. However, the 56K Softmodem

command set only includes partial support for the standard. For complete detail of the standard form

of this command, refer to recommendation V.251.

+A8T=<sig-

nal>,<1st_message>,<2nd_message>,<sig_en>,<msg_en>,<supp_delay>—Send

V.8 bis Signal and/or Message

This command instructs the DCE to send a V.8 bis signal or message. This

command is only supported when V.80 is enabled.

Value Description

1 Enables DCE-controlled V.8 origination negotiation (default).

6 Enables DCE-controlled V.8 origination negotiation, issue +A8x indications.

Value Description

1 Enables DCE-controlled V.8 answer negotiation (default).

5 Enables DCE-controlled V.8 answer negotiation, issue +A8x indications.

Value Description

1 Enables DCE-controlled V.8 origination negotiation.

6 Enables DCE-controlled V.8 origination negotiation, issue +A8x indications.

Value Description

0 Disables V.8 negotiation.

1 Enables DCE-controlled V8 bis negotiation (default).

2 Enables DTE-controlled V.8 negotiation.

Command Description

+A8E=<v8o>,<v8a>,<v8cf>,<v8b> Sets the parameters used by the modem during V.8 negotiation.

+A8E? Displays the current settings for V.8 or V.8 bis negotiation.

+A8E=? Displays the supported parameter values for the A8E commands.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 107 108

Keine Kommentare

US Robotics 56 K SOFTMODEM - COMMAND REFERENCE REV 1 Bedienungsanleitung Seite 40