US Robotics V.34 Spezifikationen PDF herunterladen (Seite 15)

2-4 MP/8 V.34: Getting Started

Figure 2-2. Mounting an MP/8 V.34 modem in a rack.

c Insert screws in the top left and top right slots and start

threading them.

d Beginning with the two bottom screws, tighten all four

until the unit is secure.

Setting the DIP Switches

The DIP switches, located on the rear panel between the RS-232

and Telco ports, are for adapting the modem to your equipment

and system requirements. Each set of DIP switches controls 8

modems.

Figure 2.3 shows the DIP switches in their factory default

settings, which reflect typical system requirements such as:

Auto Answer enabled, no result codes, no Data Terminal Ready

or Carrier Detect override. See Table 2.1 for switch options to

decide if the factory settings need to be changed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 32 33

Keine Kommentare

US Robotics V.34 Spezifikationen Seite 15